Comparison of Critical Responses of Pavements Obtained from Nonlinear Analysis Using Multilayered Theory and Finite Element Method

Document Type : Original Article

Authors

1 Associate Professor, Department of Civil Engineering, Sirjan University of Technology, Sirjan, Iran.

2 Department of Civil Engineering, Sirjan University of Technology, Sirjan, Iran

10.22034/road.2021.284943.1952

Abstract

There are several methods for analyzing flexible pavements, where the most widely used of which are the multilayerd theory and finite element method (FEM). In this study, two sections of four-layered pavement with assuming two temperatures for surface layer (25 and 40 °C) were analysed and five responses at radial distances obtained from nonlinear analysis using two methods of multilayered theory and finite element method were compared. NonPAS program is employed for nonlinear analysis of these two sections based on the multilayered theory and MICHPAVE program is used for nonlinear analysis of these two sections based on the finite element method. Also, 7 different methods have been used to determine stress points and correct stresses in the multilayered theory method. The results of the analysis showed that only for the vertical stress response on the subgrade, the results of the two programs are very different and for other responses, the difference between the two programs is reasonable. It was also found that the responses obtained from the NonPAS program for a thicker section were in better agreement with the results obtained from the MICHPAVE program. Among the 7 methods considered for determining the stress points in the multilayered method, method 7, which is based on sublayering the nonlinear layer and considering the stress points in the central depth of the sublayers and modifying the radial stresses based on the maximum tensile strength of the materials according to Mohre's failure criterion showed best conformity with the results of MICHPAVE program.

Keywords


-دفتر نظام فنی اجرایی. (1390)، "آیین‌نامه روسازی آسفالتی راه‌های ایران (نشریه شماره 234)"، تهران: معاونت برنامه‌ریزی و نظارت راهبردی رئیس‌جمهور.
-AASHTO, (1993), "Guide for Design of Pavement Structures", American Association of State Highway and Transportation Officials, Washington, D.C.
-Al-Jhayyish, A. K., (2014), "Incorporating Chemical Stabilization of the Subgrade in Pavement Design and Construction Practices (Master of Science thesis)", the Russ College of Engineering and Technology of Ohio University.
-Andrei, D., Witczak, M. W., Schwartz, C. W., & Uzan, J., (2004), "Harmonized Resilient Modulus Test Method for Unbound Pavement Materials", Transportation Research Record: Journal of the Transportation Research Board, 1874(1), pp.29–37.
-ARA Inc., (2004), "Guide for Mechanistic-Empirical Design of New and Rehabilitated Pavement Structures", Champaign
-Burmister, D. M., (1943), "The Theory of Stresses and Displacements in Layered Systems and Applications to the Design of Airport Runways. Paper Presented at the Annual Meeting", Highway Res. Board, Natl. Res. Counc., Washington, DC.
-De Jong, D. L., Peatz, M. G. F., & Korswagen, A. R., (1973), "Computer Program Bisar: Layered Systems Under Normal and Tangential Loads", External Report AMSR, Konin Klijke Shell-Laboratorium, Amsterdam.
-Finn, F., Saraf, C. L., Kulkarni, R., Nair, K., Smith, W., & Abdullah, A., (1986), "Development of Pavement Structural Subsystems (NCHRP Report 291), Transportation Research Board.
-Ghanizadeh, A. R., & Ziaie, A., (2015), "NonPAS : A Program for Nonlinear Analysis of Flexible Pavements", International Journal of Integrated Engineering, 7(1), pp.21–28.
-Harichandran, R. S., Baladi, G. Y., & Yeh, M. S., (1989), "Development of a Computer Program for Design of Pavement Systems Consisting of Layers of Bound and Unbound Materials (­FHWA-MI-RD-89-02), Final Report, Federal Highway Administration
-Hicks, R. G., & Monismith, C. L., (1971), "Factors Influencing the Resilient Response of Granular Materials", Highway Research Record, 345, pp.15–31.
-Huang, Y. H., (2004), "Pavement Analysis and Design (Second Edition)", In Englewood Cliffs, NewJersey, USA: Prentice-Hall, Incorporated.
-Hwang, D., & Witczak, M. W., (1979), "Program DAMA (Chevron), User’s Manual", Department of Civil Engineering, University of Maryland.
-Kim, M., (2007), "Three-Dimensional Finite Element Analysis of Flexible Pavements Considering Nonlinear Pavement Foundation Behavior (Ph.D. Thesis). Urbana", Champaign: University of Illinois.
-Kopperman, S., Tiller, G., & Tseng, M., (1986), "ELSYM5, Interactive Microcomputer Version", User’s Manual (Report No: FHWA-TS-87). Federal Highway Administration
-NCHRP, (1997), "Laboratory Determination of Resilient Modulus for Flexible Pavement Design", (Web Document 14 for Project
1-28), Washington, D.C: National Cooperative Highway Research Program, Transportation Research Board.
-NCHRP, (2004), "Guide for Mechanistic–Empirical Design of New and Rehabilitated Pavement Structures (Final Report for Project 1-37A)", Washington, D.C: National Cooperative Highway Research Program, Transportation Research Board.
-Raad, L., & Figueroa, J. L., (1980), "Load Response of Transportation Support Systems", Transportation Engineering Journal of ASCE, 106(1), pp.111–128.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
-Rahman, M. M., (2017), "Characterization of Subgrade Resilient Modulus for MEPDG and The Effects on Pavement Rutting (Ph.D. Thesis)", South Carolina: University of South Carolina.
-Selvi, P., (2015), "Fatigue and Rutting Strain Analysis on Lime Stabilized Subgrades to Develop a Pavement Design Chart", Transportation Geotechnics, 2, pp.86–98.
-Thompson, M. R., & Robnett, Q. L., (1979), "Resilient Properties of Subgrade Soils. Transportation Engineering Journal", 105(1), pp.71–89.
-Uzan, J., (1985), "Characterization of Granular Materials", Transportation Research Record, 1022(1), pp.52–59.
-Warren, H., & Dieckmann, W. L., (1963), "Numerical Computation of Stresses and Strains in a Multiple-Layer Asphalt Pavement System", International Report, Chevron Research Corporation, Richmond, CA.
-Witczak, M. W., & Uzan, J., (1988), "The Universal Airport Pavement Design System", Report I of IV: Granular Material Characterization. USA: University of Maryland, College Park.